FRICTION MODIFIERS

Choose friction-modifier chemistry for the required friction response, with clear checks for the lubricant, contact materials and application.

QR Code
Scan the QR code to continue on your phone

GMO

Friction modifiers — Product Routes

We supply friction modifiers for lubricant-development enquiries where the desired friction behaviour is defined by the application. Listed routes include organic friction modifiers, ester-based products, GMO, MoDTC and MoDTP.

These are formulation components with different chemistry and possible overlapping functions. The collection does not assign one friction reduction, fuel-economy result or wear benefit to every product.

Our lubricant additives range supports the complete formulation. Where wear or severe-load protection is the primary objective, review the separate anti-wear and EP requirements alongside friction control.

Applications and Friction Targets

The desired friction response depends on the contact and its function. Reducing friction can be useful in a specified engine or industrial application, while a clutch or friction-coupled system may require a carefully controlled friction characteristic rather than the lowest possible value.

Define materials, load, speed, temperature and lubrication regime before comparing components. A simple laboratory friction result does not establish performance across every operating condition.

For UAE blenders, identify whether the project targets an engine-oil claim, an industrial contact, a specific friction test or an existing formulation problem. The correct screening programme follows that objective.

Chemistry Selection Guide

Component route Information to compare Formulation consideration
Organic modifier Exact chemistry and intended use Surface interactions and compatibility
Ester-based modifier Grade composition and base-oil fit Solubility, materials and oxidation balance
GMO Documented identity and supplied composition Performance in the intended additive system
MoDTC or MoDTP Exact organomolybdenum grade and functions Elemental contribution and interaction with other components

A supplier comparison should establish both chemistry and concentration basis. Equal dose or equal molybdenum content does not automatically produce the same friction response in different finished oils.

Friction-sensitive example

A development oil needs a controlled clutch-friction characteristic. Screen the candidate against that requirement rather than selecting the lowest bench-test friction result. The desired response is defined by the system’s function, and reduced friction alone is not the acceptance criterion.

Compatibility and Validation

Evaluate friction modifiers with detergents, dispersants, anti-wear agents and antioxidants. Several components can interact at the working surface, so the complete formulation matters more than an isolated-component claim.

Assess the relevant friction and wear behaviour under representative conditions. Where fuel economy or another finished-oil marketing claim is required, use the appropriate evidence rather than converting a bench-test result into a universal service claim.

Include storage stability, material compatibility and other specification requirements in the development programme. An improvement in one friction result should not hide a loss elsewhere in the formulation.

Limitations and Special Applications

Do not add a friction modifier to an in-service lubricant without a supported procedure. The original oil may already contain a balanced system, and top treatment can change its intended performance.

Wet-clutch motorcycle applications and other friction-sensitive systems need their own acceptance requirement. Do not assume that a component marketed for friction reduction is suitable for them.

An organomolybdenum component does not automatically provide a finished-oil API, ACEA or OEM approval, nor does the category establish a particular fuel-saving percentage.

Technical Documents and Supply

Send the target lubricant, desired friction response, contact materials, base oil, existing additive package, required tests, composition limits, quantity and destination.

Request the selected grade's TDS and SDS, relevant composition data and formulation guidance. We use that brief to identify an appropriate friction-modifier route and confirm quotation-dependent supply conditions.

Frequently Asked Questions

Is lower friction always better?
No. The application may require a controlled friction response, especially where friction transmits power.

Do MoDTC and MoDTP perform identically?
No. Compare the exact grades, their functions and their response within the intended formulation.

Request a Technical Quotation

Discuss the target formulation, required function, technical constraints, quantity and destination with SiNDA to request the appropriate component or package route and a supply quotation. Contact us on WhatsApp: +971 56 154 4177.